Emerson Tescom ER5000 Series User Manual page 164

ER5000 — The ERTune™ Program: Basic Features
CAUTION
If you are modifying a Profile that has been previously downloaded
Download
or saved, you must click the
Save
Profile to the ER5000 or the
the PC, when all modifications have been done. Otherwise, the updates
will be lost when you close the ERTune™ program.
A Profile must be downloaded to the ER5000 if you wish to use it to
run the controller.
To add a command line (segment) to a Profile
1. Click within the Profile Window to select a segment of the
current Profile. The new command will be added BEFORE the
segment you select.
2. Select a command from the drop-down
OR
Click the Ramp, Dwell
or
which are the most commonly used Profile segments, can be
accessed directly using these "hot" buttons.
3. The Segment Types Window displays the entry fields to set
the parameter values for the command.
4. Enter or select the values for the command.
Insert
5. Click the Button. The command is added to the Profile
Window above the selected segment.
button to download the updated
button to save the updated Profile to
Segment Types
Step
button. These three commands,
To modify a segment in a Profile
1. Click within the Profile Window to select the segment. It may
be necessary to scroll to locate the segment line.
2. The parameter entry fields will appear in the Segment Type
Window with the current values displayed.
3. Enter the new values.
Modify
4. Click the
the new values.
To delete a segment from a Profile
5. Click within the Profile Window to select the segment. It may
be necessary to scroll to locate the segment line. Click the
Delete
Button. The segment is immediately deleted.
To add comments to a Profile
list.
1. Enter comments in the Profile Comments Block. The
Comments Block is the bottom panel of the Profile Tab.
2. Press the Tab key when you are done.
NOTE NOTE
Each Profile has a single comment block to hold all comments.
CAUTION CAUTION
To use a Profile to control the ER5000
1. Check that the Profile has been downloaded to the controller.
WARNING WARNING
2. Select Profile in the Setpoint Source field of the Tuning Tab.
Refer to Selecting a Setpoint
3. Click the Start button.
Button. The segment will be updated with
Source.
164