Connecting - Siemens SIMATIC Ident System Manual

If the wide-range power supply unit for SIMATIC RF systems is used for an end product
other than one from the SIMATIC RF family, the following must be taken into account:
● The electric strength test of the end product is to be based upon a maximum working
voltage of: Transition from primary to SELV: 353 VDC, 620 Vpk
● The following secondary output circuits are SELV (low voltage; SELV = Safety Extra Low
Voltage): all
● The following secondary output circuits are at non-hazardous energy levels: all
● The power supply terminals and/or connectors are suitable for field wiring if terminals are
provided.
● The maximum investigated branch circuit rating is: 20 A
● The investigated pollution degree is: 2
Liability
If the wide-range power supply unit for SIMATIC RF systems is connected to an end
product other than one from the SIMATIC RF family, the end user is responsible and liable
for operation of the system or end product that includes the wide-range power supply unit
for SIMATIC RF systems.
NOTICE
Restriction to the approval of the wide-range power supply
The SIMATIC RF290R reader may only be operated with power supplies that have
received KETI approval. There is currently no KETI approval for the wide-range power
supply (6GT2898-0AAx0), which is why it may not be operated in South Korea.
To be able to operate the SIMATIC RF290 reader in South Korea, use only a power unit
that meets the following requirements: 230 VAC, 24 VDC / 3 A; KC safety approved
A.2.3.5

Connecting

● There are three different (country-specific) mains cables for the EU, UK and US.
The appropriate mains cable must be connected to the primary input of the power supply.
Note
It is only permissible to insert or remove the mains cable when the power supply is de-
energized.
● The wide-range power supply unit has total insulation (Safety Class 2), IP65
● It can be mounted using four fixing holes.
SIMATIC RF200
System Manual, 07/2015, J31069-D0227-U001-A9-7618
WARNING
Appendix
A.2 Accessories
323