System Diagnostics; Error Codes Of The Rf200 Readers - Siemens SIMATIC Ident System Manual

System diagnostics

9.1

Error codes of the RF200 readers

Note
Validity of the error codes
The following error codes apply only to RF200 readers with an S-422 interface (CM mode)
You can determine the error code in two ways:
● directly on the reader/CM by counting the flashing pattern of the red error LED
● Through the FB45 variable "error_MOBY".
Table 9- 1
Flashing of
red LED on
reader
00
02
05
06
12
13
19
20
21
24
25
28
30
SIMATIC RF200
System Manual, 07/2015, J31069-D0227-U001-A9-7618
Error codes of the RF200 readers
Error code Description
(hexa-
decimal)
00 no error
01 Presence error, possible causes:
The active command was not carried out completely
•
The transponder left the antenna field while the command was
•
being processed - communication disruption between reader and
transponder
05 Parameterization error, possible causes:
Unknown command
•
Incorrect parameter
•
Function not allowed
•
06 Air interface faulty
0C The transponder memory cannot be written, possible cause:
Hardware fault (memory faulty)
0D Error in the specified memory address (access attempted to non-
existent or non-accessible memory areas).
13 Buffer overflow: Insufficient buffer available in the reader for saving
the command
14 Major system fault (hardware fault)
15 Parameter assignment error: faulty parameter in RESET command
18 Only a RESET command is permitted
19 Previous command is still active
1C Antenna is already switched off/Antenna is already switched on
1E Incorrect number of characters in frame
9
305