Chrysler 300M 2002 Service Manual page 2552

Table of Contents

Advertisement

P0315-NO CRANK SENSOR LEARNED —
TEST
2
NOTE: The conditions that set the DTC are not present at this time. The
following list may help in identifying the intermittent condition.
WARNING: WHEN THE ENGINE IS OPERATING, DO NOT STAND IN A
DIRECT LINE WITH THE FAN. DO NOT PUT YOUR HANDS NEAR THE
PULLEYS, BELTS OR FAN. DO NOT WEAR LOOSE CLOTHING.
With the engine running at normal operating temperature, monitor the DRBIII
parameters related to the DTC while wiggling the wire harness. Look for parameter
values to change and/or a DTC to set.
Review the DRBIII Freeze Frame information. If possible, try to duplicate the
conditions under which the DTC was set.
Refer to any Technical Service Bulletins (TSB) that may apply.
Visually inspect the related wire harness. Look for any chafed, pierced, pinched, or
partially broken wires.
Visually inspect the related wire harness connectors. Look for broken, bent, pushed
out, or corroded terminals.
Were any of the above conditions present?
Yes → Repair as necessary
→ Test Complete.
No
3
Visually inspect the CKP wire harness. Look for any chafed, pierced, pinched, or
partially broken wires.
Visually inspect the CKP wire harness connectors. Look for broken, bent, pushed out,
or corroded terminals.
Ensure the Crankshaft Position Sensor properly installed and the mounting bolt(s)
tight.
Refer to any TSB that may apply.
Were any of the above conditions present?
Yes → Repair as necessary
→ Go To 4
No
4
Turn the ignition off.
Remove the Crankshaft Position Sensor.
Inspect the Tone Wheel/Flex Plate slots for damage, foreign material, or excessive
movement.
Were any problems found?
Yes → Repair or replace the Tone Wheel/Flex Plate as necessary.
→ Go To 5
No
5
If there are no possible causes remaining, view repair.
Repair
ACTION
Perform POWERTRAIN VERIFICATION TEST VER - 5.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
Replace the Crankshaft Position Sensor.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
DRIVEABILITY - NGC
Continued
123
APPLICABILITY
All
All
All
All

Advertisement

Table of Contents
loading

This manual is also suitable for:

Concorde 2002Intrepid 2002

Table of Contents