Chrysler 300M 2002 Service Manual page 2565

DRIVEABILITY - NGC
Symptom:
P0340-CAMSHAFT POSITION SENSOR CIRCUIT
When Monitored and Set Condition:
P0340-CAMSHAFT POSITION SENSOR CIRCUIT
When Monitored: Engine cranking/running. Battery voltage greater than 10 volts.
Set Condition: At least 5 seconds or 2.5 engine revolutions have elapsed with crankshaft
position sensor signals present but no camshaft position sensor signal. One Trip Fault.
INTERMITTENT CRANKSHAFT POSITION SENSOR SIGNAL
INTERMITTENT CAMSHAFT POSITION SENSOR SIGNAL
5 VOLT SUPPLY CIRCUIT SHORTED TO GROUND
5 VOLT SUPPLY CIRCUIT OPEN
5 VOLT SUPPLY CIRCUIT SHORTED TO VOLTAGE
CAMSHAFT POSITION SENSOR SIGNAL CIRCUIT SHORTED GROUND
CAMSHAFT POSITION SENSOR SIGNAL CIRCUIT OPEN
CAMSHAFT POSITION SENSOR SIGNAL CIRCUIT SHORTED TO VOLTAGE
CAMSHAFT POSITION SENSOR SIGNAL SHORTED TO 5 VOLT SUPPLY CIRCUIT
SENSOR GROUND CIRCUIT OPEN
PCM - 5 VOLT SUPPLY
PCM - CAMSHAFT POSITION SENSOR SIGNAL
CAMSHAFT POSITION SENSOR
TEST
1 With the DRBIII , read the Current Camshaft Position (CMP) Sensor State while
cranking the engine.
Does the DRBIII display Current CMP State Present while cranking the engine.
Yes → Go To 2
→ Go To 4
No
POSSIBLE CAUSES
ACTION
136
APPLICABILITY
All