Chrysler 300M 2002 Service Manual page 2192

Symptom:
*EVIC INOPERATIVE
FUSED B(+) CIRCUIT OPEN
FUSED IGNITION SWITCH OUTPUT CIRCUIT OPEN
GROUND CIRCUIT OPEN
ELECTRONIC VEHICLE INFORMATION CENTER
TEST
1 NOTE: Diagnose and repair any BCM, PCM, or COMMUNICATION DTCs
before proceeding.
Turn the ignition off.
Disconnect the Overhead Console harness connector.
Measure the voltage between the Fused B+ circuit and ground.
Is the voltage above 10.5 volts?
Yes → Go To 2
→ Repair the Fused B+ circuit for an open.
No
2 Turn the ignition off.
Disconnect the Overhead Console harness connector.
Turn the ignition on.
Measure the voltage between the Fused Ignition Switch Output circuit and ground.
Is the voltage below 10.5 volts?
Yes → Repair the Fused Ignition Switch Output circuit for an open.
→ Go To 3
No
3 Turn the ignition off.
Disconnect the Overhead Console harness connector.
Measure the resistance between ground and the EVIC ground circuit.
Is the resistance above 5.0 ohms?
Yes → Repair the Ground circuit for an open.
→ Replace the EVIC in accordance with the Service Information. If
No
POSSIBLE CAUSES
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
the vehicle is equipped with TPM, the EVIC must be retrained.
Perform BODY VERIFICATION TEST - VER 1.
OVERHEAD CONSOLE
469
APPLICABILITY
All
All
All