Chrysler 300M 2002 Service Manual page 2712

Symptom:
P2008-SHORT RUNNER SOLENOID CIRCUIT
When Monitored and Set Condition:
P2008-SHORT RUNNER SOLENOID CIRCUIT
When Monitored: The Engine running. ASD Relay is energized.
Set Condition: The PCM sense the SRV is not at the desired state. One Trip Fault.
INTERMITTENT CONDITION
SHORT RUNNER VALVE SOLENOID OPERATION
ASD RELAY OUTPUT CIRCUIT
SRV SOLENOID CONTROL CIRCUIT SHORTED TO ASD RELAY OUTPUT CIRCUIT
SRV SOLENOID CONTROL CIRCUIT SHORTED TO GROUND
SRV SOLENOID CONTROL CIRCUIT OPEN
PCM
TEST
1 Ignition on, engine not running.
With the DRBIII , read DTCs and record the related Freeze Frame data.
Is the Good Trip Counter displayed and equal to zero?
Yes → Go To 2
→ Go To 8
No
2 Turn the ignition off.
Disconnect the Short Runner Valve Solenoid harness connector.
Turn the ignition on.
Using a 12-volt test light, connect one end to the ASD Relay Output circuit and the
other end to the SRV Solenoid Control circuit.
With the DRBIII , actuate the SRV Solenoid.
Does the 12-volt test light flash on and off.
→ Go To 3
No
Yes → Replace the Short Runner Valve Solenoid.
3 Turn the ignition off.
Disconnect the SRV Solenoid harness connector.
Turn the ignition on.
Using a 12-volt test light connected to ground, check the ASD Relay Output circuit.
With the DRBIII , actuate the SRV Solenoid.
Does the 12-volt test light illuminate?
Yes → Go To 4
→ Repair the ASD Relay circuit.
No
POSSIBLE CAUSES
ACTION
Perform POWERTRAIN VERIFICATION TEST VER - 5.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
DRIVEABILITY - NGC
283
APPLICABILITY
All
All
All