Chrysler 300M 2002 Service Manual page 2683

DRIVEABILITY - NGC
Symptom:
P0633-SKIM KEY NOT PROGRAMMED IN PCM
When Monitored and Set Condition:
P0633-SKIM KEY NOT PROGRAMMED IN PCM
When Monitored: Ignition on.
Set Condition: The SKIM Key information has not been programmed into the PCM.
PROGRAMMING SKIM KEY INTO PCM
PCM
TEST
1 Ignition on, engine not running.
With the DRBIII , erase DTCs.
Using the DRBIII , program the SKIM Key information into the PCM.
Start the engine.
NOTE: If the engine will not start, crank the engine over for 15 seconds.
Crank at least 2 times with the ignition switch returning to the off position
each time.
Allow the engine to reach normal operating temperature.
With the DRBIII , read DTCs.
Does the DTC reset?
Yes → Replace and program the Powertrain Control Module in accor-
→ The SKIM KEY information has been succcessfully programmed
No
POSSIBLE CAUSES
ACTION
dance with the Service Information.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
into the PCM. Test is complete.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
254
APPLICABILITY
All