Chrysler 300M 2002 Service Manual page 2755

VERIFICATION TESTS
Verification Tests —
POWERTRAIN VERIFICATION TEST VER - 3
1. NOTE: After completing the Powertrain Verification Test the Transmission Veri-
fication Test must be performed.
2. NOTE: If the PCM has been replaced and the correct VIN and mileage have not
been programmed, a DTC will be set in the ABS Module, Airbag Module and the
SKIM.
3. NOTE: If the vehicle is equipped with a Sentry Key Immobilizer System, Secret
Key data must be updated. Refer to the Service Information for the PCM, SKIM and
the Transponder (ignition key) for programming information.
4. Inspect the vehicle to ensure that all components related to the repair are connected
properly.
5. With the DRBIII , clear DTCs.
6. Perform generator output test. Refer to the appropriate service information as necessary.
7. Start the engine and set engine speed to 2000 RPM for at least thirty seconds.
8. Cycle the ignition key off and on.
9. With the DRBIII , read the DTCs. If the DTC returns, or any other symptom or DTC is
present, refer to the appropriate category and perform the corresponding symptom.
10. If there are no DTCs present and all components are functioning properly, the repair is
complete.
Are any DTCs present?
Yes → Repair is not complete, refer to appropriate symptom.
→ Repair is complete.
No
Continued
326
APPLICABILITY
All