Chrysler 300M 2002 Service Manual page 2200

DECKLID RELEASE SOLENOID OUTPUT FAILURE —
TEST
8 Turn the ignition off.
Disconnect the Decklid Release Solenoid/Ajar Switch harness connector.
Remove the Body Control Module from the Junction Block.
Measure the resistance of the Decklid Release Control circuit between the Decklid
Release Solenoid/Ajar Switch connector and the Junction Block Body Control Module
connector (cavity 8).
Is the resistance below 5.0 ohms?
Yes → Go To 9
No
9 If there are no possible causes remaining, view repair.
Repair
ACTION
→ Repair the Decklid Release Control circuit for an open.
Perform BODY VERIFICATION TEST - VER 1.
Replace the Body Control Module.
Perform BODY VERIFICATION TEST - VER 1.
POWER DOOR LOCKS/RKE
477
Continued
APPLICABILITY
All
All