Specific Commands For 62000H Series; Abort Subsystem; Configure Subsystem - Chroma 62020H-150S Operating & Programming Manual

Bit No. Bit Weight
5.6.2

Specific Commands for 62000H Series

5.6.2.1

ABORT Subsystem

ABORt
Description:
Syntax:
5.6.2.2

CONFIGURE Subsystem

1. CONFigure:BEEPer
Description:
Syntax:
Parameter:
Example:
Query Syntax:
Return Parameter: ON | OFF
Query Example:
Return Example:
2. CONFigure:REMote
Description:
Syntax:
Parameter:
Example:
Power on Bit. Rebooting the Power Supply will set
7 128
this bit to 1.
6 Always 0.
Command Error Bit. This bit is set to 1 if there is
5 32
any IEEE 488.2 syntax error.
Execution Error Bit. This bit is set to 1 when the
4 16 command parameter is out of valid range or
inconsistent.
Device Dependent Error Bit. This bit is set to 1
3 8 when too many errors have occurred and the error
queue is full.
Queue Error Bit. This bit is set to 1 when reading
2 4 data from the output buffer and no data is present,
or when the data is lost.
1 Always 0.
0 1
Sets all output states to "OFF".
ABORt
Sets the beeper to ON or OFF.
CONFigure:BEEPer ON
CONFigure:BEEPer OFF
ON|OFF
CONF: BEEPer ON
CONF: BEEPer OFF
CONFigure:BEEPer?
CONF:BEEPer?
ON or OFF
Sets the remote control status (valid for RS232C only).
CONFigure:REMote ON
CONFigure:REMote OFF
ON|OFF
CONF:REM OFF
Table 5-8
Description
Returns the beeper control status.
Disables remote control.
Remote Operation
5-27