Error Message - Chroma 62020H-150S Operating & Programming Manual

10. Press " ON/OFF " again to start program execution. The SANDIA_MODE main screen will
display as shown in Figure 3-172. To quit, press "
Figure 3-172 shows the screen during SANDIA_MODE output. The EQ_VOC, EQ_VMP,
EQ_ISC and EQ_IMP are the actual operating points that are calculated based on the
settings of VMP and PMP using the built-in formula.
Use the "
" "
or PMP parameters are changed, use "
ENTER
" " to confirm the change. The IV curve and EQ_VOC, EQ_VMP, EQ_ISC and EQ_IMP
parameters will be immediately updated.
3.3.9.6

Error Message

If invalid parameters are entered in SAS_MODE, the screen will display an error message.
EXIT
Press " " to return to OUTPUT_MODE and re-enter the correct parameters.
Figure 3-171
Figure 3-172
" keys to change the VMP and PMP parameters. When the VMP
" to move the cursor to TRIG and press
Manual Operation
" to return to the MAIN PAGE.
EXIT
3-95