Chroma 62020H-150S Operating & Programming Manual page 213

7. IVCurve:IT
Description:
Syntax:
Example:
Query Syntax:
Return Parameter: <NRf+>,...,<NRf+>
Query Example:
Return Example:
Note The execution time of this command is longer in Master/Slave mode. To ensure
normal operation, use the *OPC command. It will run the next command after the
*OPC command responds.
Ex.: IVC:VT xxx,xxx,xxx,...
*OPC?
8. IVCurve:EDIT <NR1>
Description:
Syntax:
Example:
Query Syntax:
Return Parameter: <NR1>
Query Example:
Return Example:
9. IVCurve:SELect <NR1>
Description:
Syntax:
Example:
Query Syntax:
Return Parameter: <NR1>
Query Example:
Return Example:
10. IVCurve:SEQuence:SELected
Description:
Syntax:
Parameter:
Example:
Query Syntax:
Return Parameter: <NR1>
Query Example:
Return Example:
Note Ensure the IV-Program has the desired sequence before selecting it. If not, use
the PROG:ADD command to add a new Sequence.
Creates the 128 dot current data table in IV Curve Mode.
IVCurve:IT <NRf+>...< NRf+>
Creates the current table of IV Curve data.
IVCurve:IT <I1>,<I2>,...<I128>
IVCurve:IT?
IVCurve:IT?
<I1>,<I1>,...<I128>
Selects the stored table to be edited in IV Curve Mode. There are
100 stored tables (1-100). The default is 1.
IVCurve:EDIT <NR1>
Selects the IV Curve stored in table 1 for editing.
IVCurve:EDIT 1
IVCurve:EDIT?
IVCurve:EDIT?
1
Selects the stored table to be run in IV Curve Mode. There are 100
stored tables (1-100). The default is 1.
IVCurve:SELect <NR1>
Selects the IV Curve stored in table 1 for execution.
IVCurve:SELect 1
IVCurve:SELect?
IVCurve:SELect?
1
Selects the sequence of the programs for the IV_PROGRAM.
IVCurve:SEQuence:SELected <NR1>
1 to 100
IVC:SEQ:SEL 3
IVC:SEQuence:SELected?
IVC:SEQ:SEL?
3
Remote Operation
5-43