Setting Parallel Parameters - Chroma 62020H-150S Operating & Programming Manual

Programmable DC Power Supply (with Solar Array Simulation) 62000H Series
Operating & Programming Manual
ΣV
L I M I T :
I L I M I T :
ΣV
S L E W R A T E =
I S L E W R A T E = I N F .
V D C _ R
3.3.3.4.4 Setting PROTECTION for Series
The OVP and OPP [PROTECTION] settings in the MASTER unit in a series connection will
increase based on the number of units connected in series. They are indicated by ΣOVP
and ΣOPP for easy identification as shown in Figure 3-51 below.
∑ O V P
O C P
∑ O P P
R E M O T E
S A F E T Y
E X T O N / O F F
3.3.3.5

Setting Parallel Parameters

The following parameter setting screens display once the software communication and
hardware settings for parallel operation are completed - (1) MAIN PAGE, (2) SYSTEM
SETUP, (3) OUTPUT SETUP and (4) PROTECTION.
3.3.3.5.1 Setting MAIN PAGE
MAIN PAGE is used to set voltage (V) and current (I). The difference between single unit
and parallel operation is that the current setting will increase according to the number of units
connected in parallel. The current setting is indicated by ΣI for easy identification. When
set to MASTER, MST will appear in the window's upper right corner as shown in Figure 3-52
below.
3-32
M A X = 6 0 0 . 0 _ V
M A X = 2 5 . 0 0
1 . 0 0 0 ( V / m S )
( A / m S )
= 6 . 0 V
Figure 3-50
=
=
= 1 0 5 0 0 . 0 W
I N H I B I T =
I N T . L O C K =
=
Figure 3-51
[O U T P U T
M I N =
A M I N =
V D C _ F = 6 . 0 V
[ P R O T E C T I O N ]
6 0 0 . 0 _ V
1 8 . 9 0 A
D I S A B L E P U L L = H I G H
D I S A B L E P U L L = H I G H
D I S A B L E P U L L = H I G H
S E T U P]
0 . 0 V
0 . 0 A
▼