3.3.1
SYSTEM SETUP
1.
In the Config setup page, press "
Figure 3-5. Use the "
selection.
A P G V S E T
A P G I S E T
A P G V M E A S
A P G I M E A S
B U Z Z E R
P O W E R O N S T A T U S =
3.3.1.1
APG
The Analog Programming interface (APG) performs the following two functions: 1. uses the
analog signal control panel to set the value and 2. uses the analog signal to indicate the panel
measurement. The values for set and measure can be set separately as described below.
1.
Use the "
Figure 3-6.
A P G V S E T
A P G I S E T
A P G V M E A S
A P G I M E A S
B U Z Z E R
P O W E R O N S T A T U S =
2.
For APG VSET, use the numeric keys
the mode. There are 5 selections for APG VSET: NONE / Vref(0-5V) /Vref(0-10V) /
Iref(4-20mA)/ Rref(0-5KOhm), where:
NONE: means not using the programming function.
Vref(0-5V): means using the external voltage source as the programming setting.
Vref(0-10V): means using the external voltage source as the programming setting.
Iref(4-20mA): means using the external voltage current source as the programming
setting.
Rref(0-5KOhm): means using the external resistance as the programming setting.
ENTER
3.
Press "
" to confirm.
1
", "
=
N O N E _
=
N O N E
=
N O N E
=
N O N E
=
O N
D E F A U L T
Figure 3-5
", "
" keys to move the cursor to the column to be set as shown in
=
N O N E _
=
N O N E
=
N O N E
=
N O N E
=
O N
D E F A U L T
Figure 3-6
ENTER
" then "
" to display the screen shown in
" keys to move the cursor to the desired
[S Y S T E M S E T U P]
[S Y S T E M S E T U P]
0
4
-
or the "Rotary" (
Manual Operation
) knob to set
3-5