Chroma 62020H-150S Operating & Programming Manual page 129

1.
2.
1. Use the "
shown in Figure 3-149.
2. Press " " to go to the ETHERNET IP address setting screen as shown in Figure
ENTER
3-150.
Auto detection:
The DHCP default is "ON" and the DC Power Supply will automatically detect the external
network IP address as shown in Figure 3-150,
Manual detection:
3. Move the cursor to DHCP and use the numeric keys
( ) knob to set the DHCP to OFF.
4. Move the cursor to IP ADDRESS and use the numeric keys
IP address.
5. Move the cursor to GATEWAY ADDR and use the numeric keys
the address.
6. Move the cursor to SUBNET MASK and use the numeric keys
the IP address.
7. Move the cursor to APPLY and use the numeric keys
"Rotary" ( ) knob to set APPLY to YES.
8. Press " " to confirm.
ENTER
9. Press " " to return to the MAIN PAGE.
EXIT
Connect the network cable to the DC Power Supply for auto
detection.
If the network cable is not connected properly, it may cause the DC
Power Supply screen to display incorrectly. Turn OFF the DC
Power Supply, resolve the network cable problem, and reboot it to
clear the abnormal screen.
", " " keys to move the cursor to the ETHERNET column as
Figure 3-149
Manual Operation
1
0 - or turn the "Rotary"
9
0 -
0 -
9
0
-
1
0 - or turn the
to set the
9
to set
to set
3-81