Program List Mode Description; V_Step Mode - Chroma 62020H-150S Operating & Programming Manual

Programmable DC Power Supply (with Solar Array Simulation) 62000H Series
Operating & Programming Manual
1.
2.
4.1.3.2

Program List Mode Description

Figure 4-17 shows the main execution page of LIST MODE. Items (1) - (5) in the figure are
explained below.
S E Q S T A T U S =
P R G N O . = 1
0 . 0 0 0 0 V
(1)
Program Number: PRG NO. indicates the current Program Number being executed.
(2)
Sequence Number: SEQ NO. indicates the current Sequence Number being executed.
(3)
Sequence Status: SEQ STATUS indicates the current Sequence state being executed.
(4)
Count_Remain: COUNT_REMAIN indicates the remaining number of sequences to be
executed for the current Program.
(5)
Running Time: TIME indicates the total time for program execution.
The time format is HOUR:MIN:SEC and the maximum display limit is 99 hours 59 minutes
and 59 seconds. If the accumulated time exceeds the maximum display limit, it will reset to 0
and restart the clock.
4.2

V_STEP MODE

A run time program can be set in V_STEP MODE. Figure 4-18 shows the screen when
V_STEP MODE is selected.
4-16
ON/OFF
Pressing " " in the Program page (Figure 4-3) or Sequence
page (Figure 4-8) will display a confirmation page as shown in Figure
4-15.
EXIT
Pressing " " will abort the executing program and shut off the
Power Supply output.
A U T O
S E Q N O . = 1
( 1 )
Figure 4-17
T I M E = 0 0 0 : 0 0 : 20
( 3 )
C O U N T _ R E M A I N = 0
( 2 )
0 . 0 0 0 0 A
( 5 )
( 4 )
0 . 0 W