Diagnostic Information And Procedure; Ignition System - SSANGYONG Y200 Manual

DIAGNOSTIC INFORMATION AND PROCEDURE

Condition
No Crank
Crank OK, But Too Slow
Starter Motor Does Not Stop
Starter Motor Running, But Not
Cranking
Battery Discharge
Charging Indicator Lamp Does Not
Work When the Ignition Switch ON
(Engine Does Not Work)
Charging Indicator Lamp Does Not
Put Out Lights After Starting the
Engine
Battery Over Charging
SSANGYONG Y200

IGNITION SYSTEM

Probable Cause
•
Low battery voltage.
•
Battery cable is loose,
corroded, or damaged.
•
Faulty starter motor or starter
motor circuit is open.
•
Faulty ignition switch.
•
Ground short.
•
Low battery voltage.
•
Battery.
•
Battery cables are loose,
corroded, or damaged.
•
Faulty starter motor.
•
Faulty starter motor.
•
Faulty ignition switch.
•
Broken the clutch pinion gear or
faulty starter motor.
•
Broken the flywheel ring gear.
•
Connected circuit is open.
•
Loosen the generator drive belt.
•
The circuit is open or a short.
•
Battery run down.
•
Open ground circuit.
•
Charging indicator lamp is
blown or fuse is blown.
•
Faulty ignition switch.
•
Generator ground circuit is
open or a short.
•
Battery cable is corroded or
damaged.
•
Loosen the generator drive belt.
•
Faulty wiring harness.
•
Generator Voltage Regulator
Faulty
•
Voltage detecfing wiring faulty
ENGINE ELECTRICAL 1E-5
Correction
•
Charging the battery or Replace
the battery.
•
Repair or Replace the battery
cable.
•
Repair or Replace the starter
motor/starter motor circuit.
•
Replace the ignition switch.
•
Repair the ground short.
•
Charging the battery or Replace
the battery.
•
Repair or Replace the battery
cable.
•
Repair or Replace the starter
motor.
•
Repair or Replace the starter
motor.
•
Replace the ignition switch.
•
Replace the starter motor.
•
Replace the flywheel.
•
Repair the open circuit.
•
Adjust the belt tension or
Replace the belt.
•
Repair the open or a short
circuit.
•
Replace the battery.
•
Repair the open ground circuit.
•
Repair or Replace the charging
indicator lamp/fuse.
•
Replace the ignition switch.
•
Repair the circuit.
•
Repair or Replace the battery
cable.
•
Adjust the belt tension or
Replace the belt.
•
Repair the wiring harness.
•
Replace Generator
•
Repair Wiring