SSANGYONG Y200 Manual page 498

1E-24 ENGINE ELECTRICAL
5. Remove the front bearing.
•
Remove the support plate screws (1).
•
Remove the plate (2).
•
Remove the front bearing using the press (3).
YAD1E510
6. Remove the battery positive terminal nut from the
rear bracket.
•
Remove the battery position terminal nut (1).
•
Remove the washer (2).
YAD1E520
7. Remove the stator assembly from the rear bracket.
•
Remove the rectifier screw (1).
•
Remove the brush holder and regulator
assembly screw (2).
•
Remove the stator assembly with the rectifier /
brush holder / regulator (3).
YAD1E530
8. Remove the rectifier / brush holder / regulator from
the stator.
•
Remove the rectifier / brush holder / regulator
connections (1).
•
Remove the stator and rectifier connections (2).
Notice: If the stator connections are welded, melt
the lead. Avoid overheating as it can damage the
diodes.
YAD1E540
SSANGYONG Y200