10.2
DR-SBA Configuration
This section describes DR-SBA configuration operations that can be performed through the
SBA Management Interface (in addition to configuration through the SBA Setup Wizard
described in Chapter 5).
10.2.1 Viewing and Configuring Network Interfaces
The device includes the following network interface cards (NIC):
OSN SBA:
External Ethernet Ports:
•
•
If there are two or four external interfaces, NIC teaming is used between the first
two.
♦
♦
♦
GE 3 and GE 4 are available only for specific HW
Internal Ethernet Port: By default, the NIC is enabled and enabled for DHCP
•
Virtual SBA:
The virtual machine virtual network interface is listed
To view and configure network interfaces:
1.
From the Setup menu, select the Setup folder, and then click Network:
Figure 10-4: Viewing Network Interfaces (OSN-Based DR-SBA)
Figure 10-5: Viewing Network Interfaces (Virtual Appliance-Based DR-SBA)
2.
To disable a network interface, click Disable; to enable a network interface, click
Enable.
3.
To configure a network interface, click the required network icon; the following appears:
Installation and Maintenance Manual
External Team: By default, the NIC is enabled (192.168.0.20)
GE 3: By default, the NIC is Disable.
GE 4: By default, the NIC is Disable.
74
Mediant SBA
LTRT-33443