Safety Information For Atex Designs - ProMinent Sigma 3 Basic Operating Instructions Manual

Sound pressure level

2.1 Safety information for ATEX designs

Intended use
Qualification of personnel
3. As you have converted an "incomplete machine" into a complete
machine, you must perform a conformity assessment, risk assess‐
ment, create a Declaration of Conformity, fit a company name‐
plate, ... .
4. Complete the pump documentation / operating instructions.
Sound pressure level LpA < 70 dB according to EN ISO 20361
at maximum stroke length, maximum stroke rate, maximum back pressure
(water)
This chapter lists all safety information for ATEX designs. Safety informa‐
tion is listed again at the relevant points in these operating instructions.
This safety information is supplementary to or replaces the safety informa‐
tion for non-ATEX designs. If the safety information for ATEX designs con‐
tradicts the other safety information, then the safety information in this
chapter applies to ATEX designs.
Only operate an ATEX design pump in premises at risk from explosion
n
in accordance with the applicable guidelines.
Do not expose the ATEX design to any sources of ionising radiation or
n
electromagnetic high frequency radiation in the range 10
or laser radiation or ultrasound or lightning without putting in place
measures in line with EN 80079-38.
Do not allow the ATEX design to meter media, which tends to produce
n
exothermic reactions or self-ignite (examples of exothermic reactions:
pyrophoric substances with air, alkali metal with water, decomposition
of organic peroxides, polymerisation reactions), without taking effec‐
tive measures in accordance with EN 80079-38.
Task
Planning the hydraulic installation
Electrical installation
Start up
Maintenance, repair
Troubleshooting
Explanation of the table:
Recognised competent person
To carry out explosion hazard inspections the competent person must
have:
Completed a relevant course of study or
n
Have a comparable technical qualification or
n
Another technical qualification combined with long-term experience of
n
safety technology.
Safety chapter
... 3x10
4
Qualification
ATEX qualified person, ATEX elec‐
trical technician
ATEX electrical technician
Skilled ATEX technician;
Checking the electrical installation:
Recognised competent person
ATEX qualified person, ATEX elec‐
trical technician
Qualified ATEX technician or ATEX
electrical technician - depending on
the fault;
Checking the electrical installation:
Recognised competent person
Hz
15
15