ProMinent Sigma 3 Basic Operating Instructions Manual page 22

Safety chapter
Power end and motor – ATEX
PPT - ATEX liquid end
TTT - ATEX liquid end
SST - ATEX liquid end
Installation height
Safety equipment
Other safety equipment - ATEX labels
22
Screw in the oil drainage plug (2) with a new seal.
WARNING!
Check after 1 day whether the oil drainage plug (2) is still
tight.
Data
Ambient temperature during operation:
Data
Max. temperature, long-term at max. oper‐
ating pressure
Minimum temperature.
Data
Max. temperature, long-term at max. oper‐
ating pressure
Minimum temperature.
Data
Max. temperature, long-term at max. oper‐
ating pressure
Minimum temperature.
Data
Maximum installation height*:
* We urgently advise you to contact a specialist for ATEX motors with
higher intended installation heights!
WARNING!
– The following safety information must be affixed to
pumps that include parts made of electrically non-
conducting plastic.
– Ensure that the label is always fitted and legible.
– Do not allow other labels to be stuck over this label.
Value Unit
-10 ... +40 °C
Value Unit
50 °C
-10 °C
Value Unit
50 °C
-10 °C
Value Unit
90 °C
-10 °C
Value Unit
1000 m above
standard
zero