Assembly
Inlet hose 1
➜ Shorten the supplied PTFE tube so that
the end of the tube ends in the evapo-
rating flask.
➜ Slide the drain disk onto the PTFE tube
so that it is positioned before the vapor
tube of the evaporating flask.
✓ This prevents condensed fluid from
flowing back into the evaporating flask
via the inlet hose.
➜ Unscrew the screw cap from the
condenser.
➜ Slide the seal ring and screw cap about 3
cm onto the PTFE tube.
➜ Insert the inlet valve with the inlet hose into the inlet opening of the condenser and
tighten the screw cap.
Inlet hose 2
➜ Slide the PTFE tube onto the feed
opening.
✓ The inlet hoses are installed.
Glassware set G1 inlet hoses
The opening for the inlet hoses is located at
the top of the condenser.
Inlet valve
Screw cap
Ventilation cap
Inlet valve
Opening for inlet hose 2
G1: Inlet hose screw cap 1
Opening for inlet hose 2
90
Drain disk
Vapor tube
Inlet hose 1