Heidolph Hei-VAP Expert Operating Manual page 24

Start-up
Toolbar: Numbers
➜ Tap the number of a setpoint.
➜ The adjacent numbers menu is
displayed.
➜ Tap the respective number to enter the
desired parameter value.
✓ If you enter an invalid value, the valid
range of values is indicated for a short
time.
➜ Tap the green checkmark to confirm
your entry.
➜ Tap the red cross to cancel your entry.
Open submenus
➜ Swipe the control panel from left to right (or the other way round) to switch to the
next screen.
In all three operating modes, small squares
appear at the bottom edge of the screen,
the quantity of which indicates the page
number of the submenus.
Additionally active elements are highlighted in color in the schematic drawing of the
device. For example, if the heating is switched on, the heating bath is lit orange.
If a vacuum pump or a chiller of series Hei-CHILL is attached, their setpoints and actual
values are also displayed on the start page with the symbol for switching on and off. The
setpoint can be changed by tapping on the corresponding number.
The values for rotation, temperature and vacuum can be adjusted
both by means of the touch-sensitive control panel or by means of the
rotary knob (see subsequent page).
Setpoints on the start page:
The setpoints are displayed in small print
above the line. The actual values are
displayed in large print below the line.
When adjusting a setpoint with the rotary
knobs, this value is displayed in larger print
and in orange for a short time.
Information on submenus (example)
Setpoint
Current assignment of
the rotary knob
24
Actual value
Setpoint during
entry