Process Factor Units - AUMA AC 01.2 Manual

Basic settings for commissioning
Function not active
Function active
7.5.7.

Process factor units

Function not active
Function active
44
may be adapted. The change-over affects all screens indicating a position. This
includes status pages such as S0001 S0002, but also the representation of
characteristics (e.g. position-time) as well as histograms.
Activate position unit
Required user level: Specialist (4) or higher.
Display... M0009
Units M1205
Position M1206
Activation M1207
Default value: Function not active
Setting values:
<Units of position> function deactivated.
<Units of position> function activated.
Set max. value, scaling and unit
Required user level: Specialist (4) or higher.
Display... M0009
Units M1205
Position M1206
Max. value at 100.0 % M1208
Scaling M1209
Unit M1210
Process factors (e.g. process setpoint, actual process value...) are shown in percent
of travel in the AC display (default setting). By activating the parameter Process
factor, you may select other physical units instead of percent. The change-over
affects all screens indicating a process value.
Activate process factor units
Required user level: Specialist (4) or higher.
Display... M0009
Units M1205
Process factor M1211
Activation M1212
Default value: Function not active
Setting values:
<Process factor units> deactivated.
<Process factor units> activated.
Set max. value, scaling and unit
Required user level: Specialist (4) or higher.
Display... M0009
Units M1205
Process factor M1211
Max. value at 100.0 % M1213
Scaling M1214
Unit M1215
Actuator controls
AC 01.2/ACExC 01.2