Torque Switching - AUMA AC 01.2 Manual

Basic settings for commissioning
Select main menu
Select parameter
CLOSE or OPEN
Log on user
Change settings
7.2.

Torque switching

Conditions
Function
38
1. Set selector switch to position 0 (OFF).
2. Press push button C Setup and hold it down for approx. 3 seconds.
Display goes to main menu and indicates: ▶ Display...
3. Select parameter either:
click via the menu
via direct display: press
Display indicates: End position CLOSED
4. Use Up ▲ Down ▼ to select:
▶ End position CLOSED
▶ End position OPEN
The black triangle ▶ indicates the current selection.
5. Press Ok.
Display indicates the current setting: Limit or Torque
The bottom row of the display indicates either:
- Edit → continue with step 6
- Save → continue with step 10
6. Press Edit.
Display indicates: ▶ Specialist (4)
7. Use Up ▲ Down ▼ to select user:
Information: Required user level: Specialist (4) or higher
The symbols have the following meaning:
- black triangle: ▶ = current setting
- white triangle: ▷ = selection (not saved yet)
8. Press Ok.
Display indicates: Password 0***
9. Enter password (→ enter password).
The screen indicates the pre-set type of seating (▶ Limit or ▶ Torque) by means
of a black triangle ▶.
10. Select new setting
The symbols have the following meaning:
- black triangle: ▶ = current setting
- white triangle: ▷ = selection (not saved yet)
11. Confirm selection via
The setting for the type of seating is complete.
12. Back to step 4 (CLOSED or OPEN): Press
MWG in actuator (Non-intrusive version).
For torque switches in the actuator (Intrusive version), the torque switching is set as
described in the operation instructions.
Overload protection across full travel
Tripping in end positions (for torque seating)
Tripping in during manual operation also possible
to parameter, or
and enter ID M0086 or M0087
Up ▲ Down ▼ resulting in the following significations:
Save.
Esc .
Actuator controls
AC 01.2/ACExC 01.2