AUMA AC 01.2 Manual page 28

Signals (output signals)
28
Device configuration M0053
Config. of signals M0860
Failure (configurable) M0879
Fault (Cfg) M0880
Warnings (Cfg) M0881
Not ready REMOTE (Cfg) M0882
Default values Failure (configurable):
☑ = activated
☑ Fault (Cfg)
☑ Warning (Cfg)
☑ Not ready REMOTE (Cfg)
Default values Fault (Cfg):
☑ = activated
☑ Configuration error
☑ Config. error REMOTE
☑ Internal error
☑ Torque fault CLOSE
☑ Torque fault OPEN
☑ Phase fault
☑ Incorrect phase seq
☑ Mains quality
☑ Thermal fault
☑ Fault no reaction
Default values Warnings (Cfg):
☑ = activated
☑ Config. warning
☑ Internal warning
☑ Wrn input AIN 1
☑ Wrn input AIN 2
☑ Wrn setpoint position
☑ Not used
☑ Maintenance required
Default values Not ready REMOTE (Cfg):
☑ = activated
☑ Wrong oper. cmd
☑ Sel. sw. not REMOTE
☑ Service active
☑ Disabled
☑ EMCY stop active
☑ EMCY behav. active
☑ I/O interface
☑ Handwheel active
☑ FailState fieldbus
☑ Local STOP
Actuator controls
AC 01.2/ACExC 01.2