Leuze electronic
8.2
Requirement for firmware update
Before running the firmware-update, ensure the following points:
–
The MSI 100 or MSI 200 safety module is connected to the PC via the USB cable and
switched on.
–
The AC-MSI-CFG1 memory module is plugged into the safety module.
–
A project for the safety module is loaded in the MSIsafesoft configuration software.
–
Simulation mode for the MSIsafesoft configuration software is switched off.
Displayed in the status line of the MSIsafesoft configuration software is:
–
"Control: Connected" and "Control: Logged off".
–
Displayed in the status line of the MSIsafesoft configuration software is:
"Project: Write protected".
8.3
Running a firmware update
1.
To start the firmware update in the MSIsafesoft configuration software, select the "Safe
control > Firmware update" menu item.
The wizard, which will guide you through the update, is displayed.
2.
Proceed as described in detail in the help system.
You will find the topic "Firmware update" listed in the contents of the MSIsafesoft configura-
tion software help system.
See also "Opening the software help system" on page 9-76.
MSI 100/200
Firmware update
74