Terminals; Safety Clamp - Danfoss VLT 2800 Design Manual

Installation
Illustration 3.25 VLT 2880-2882 380-480 V
VLT 2840 PD2
NOTICE
The units are supplied with 2 bottom plates; one for
metric glands and one for conduits.
MG27E402
Design Guide

3.4 Terminals

3.4.1 Safety Clamp

Illustration 3.26 Safety Clamp
CAUTION
If the galvanic isolation (PELV) between control terminals
and high-voltage terminals is to be maintained, the
accompanying safety clamp must be fitted to VLT
2803-2815, 200-240 V, and VLT 2805-2815, 380-480 V.
Failure to fit the safety clamp could result in equipment
damage.
Danfoss A/S © Rev. May/2014 All rights reserved.
3 3
47