Pc Software - Danfoss VLT 2800 Design Manual

Introduction to VLT 2800
1 1

1.9 PC Software

MCT 10 Set-up Software
All frequency converters are equipped with a serial
communication port. Danfoss provides a PC tool for
communication between PC and frequency converter, VLT
Motion Control Tool MCT 10 Set-up Software.
MCT 10 Set-up Softwarehas been designed as an easy-to-
use interactive tool for setting parameters in the frequency
converters.
The MCT 10 Set-up Software can be used for:
•
Planning a communication network off-line. MCT
10 Set-up Software contains a complete
frequency converter database.
•
Commissioning frequency converters on line.
•
Saving settings for all frequency converters.
•
Replacing a frequency converter in a network.
•
Expanding an existing network.
•
Supporting future developed frequency
converters.
MCT 10 Set-up Software support Profibus DP-V1 via a
master class 2 connection. It makes it possible to read/
write parameters on-line in a frequency converter via the
Profibus network. This eliminates the need for an extra
communication network.
The MCT 10 Set-up Software can be downloaded at:
www.danfoss.com/BusinessAreas/DrivesSolutions/Software-
download/. Select the licensed version to use all functions,
or the free version to use limited functions.
MCT 31 Harmonic Calculation Tool
The MCT 31 Harmonic Calculation tool determines the
degree of voltage pollution on the grid and needed
precaution. Download the free MCT 31 Harmonic
Calculation Tool from www.danfoss.com/BusinessAreas/
DrivesSolutions/Softwaredownload/.
16
Design Guide
Danfoss A/S © Rev. May/2014 All rights reserved. MG27E402