Manual Initialisation - Danfoss VLT 2800 Design Manual

Introduction to VLT 2800

1.13.10 Manual Initialisation

NOTICE
Manual initialisation is not possible on the LCP 2 control
unit. Perform an initialisation with parameter 620
Operation mode.
The following parameters are not set to 0 when initialising
via parameter 620 Operation mode.
•
parameter 500 Address
•
parameter 501 Baud rate
•
parameter 600 Operating hours
•
parameter 601 Hours run
•
parameter 602 kWh counter
•
parameter 603 Number of power-ups
•
parameter 604 Number of overtemperatures
•
parameter 605 Number of overvoltages
•
parameter 615-617 Fault log
MG27E402
Design Guide
Danfoss A/S © Rev. May/2014 All rights reserved.
1 1
31