Configuring An Integrated Cni4 Device Using Serial Connection - Honeywell CNI4 Operating And Installation Manual

7 Configuration

7.4 Configuring an integrated CNI4 device using serial connection

Before configuring an integrated CNI4 site in MasterLink, ensure that you are aware of the Site ID of
Pulse Accumulator and RUID of Cloud Link 4G modem, and they must be the same.
If..
You know the Site ID of Pulse Accumulator
and RUID of Cloud Link 4G modem
You do not know the Site ID or RUID
Warning: If you have configured the Pulse Accumulator and the Cloud Link 4G Modem as separate
standalone sites in MasterLink, ensure that you delete those sites before adding a new CNI4 site as
an integrated device.
To configure a CNI4 device using serial connection:
1. Ensure that the USB-to-serial cable is connected to one of the components (Cloud Link 4G Modem
OR Pulse Accumulator) inside the CNI4 device and a computer running MasterLink software.
Attention: Do not connect and use both the black and green connectors at the same time. Only
one connector (either black OR green) can be used at any given point of time. If you are using
the black connector to connect to the Cloud Link 4G Modem, ensure that the female (green)
connector is disconnected. If you are using the green connector to connect to the Pulse
Accumulator, ensure that the male (black) connector is disconnected.
2. Launch and login to the MasterLink R510.xx desktop application.
Then..
Continue with the procedure mentioned below, and
configure the CNI4 device as an integrated site in
MasterLink.
Connect to Cloud Link 4G Modem, and Pulse
Accumulator individually over serial, and then make a
note of the Site ID and the RUID before configuring the
CNI4 device as an integrated site.
Honeywell
| 32