Honeywell CNI4 Operating And Installation Manual page 38

7 Configuration
User ID: User ID used to log-in to the device. Valid User IDs are 0 through 99
(decimal numeric).
Instrument Access code: Passcode used to log-in to the device. Valid passcodes are
00000 through 99999 (decimal numeric). The Passcode must be 5 digits in length.
Internet/Phone: None. Not applicable as the device is being configured to connect
over serial.
Other fields displayed on the screen can be left blank.
Click Save to continue.
The site is added to the list of sites on the Site Management screen.
5. Navigate to the Settings menu. In the 'Communications Setup' tab, select the Serial Port Connector
and the Baud Rate (default value = 9600) and Click OK.
Note: Note: If multiple serial port connectors are detected, then ensure that you select the
correct port using the Connector drop-down. Also, ensure that you set the baud rate to match
the baud rate of the connected instrument.
Honeywell
| 34