Honeywell CNI4 Operating And Installation Manual page 43

7 Configuration
2. Configure the CNI4's site properties.
Site Name: The name of the connected site.
Site Location: The location where the instrument is installed.
Site ID: The first eight digits of the user assigned, site identification number. The
entry is limited to only characters: 0-9, therefore characters "." and "-" are not valid.
Site ID 2: The second set of eight digit, site identification numbers.
User ID: User ID used to log-in to the device. Valid User IDs are 0 through 99
(decimal numeric).
Instrument Access code: Passcode used to log-in to the device. Valid passcodes are
00000 through 99999 (decimal numeric). The Passcode must be 5 digits in length.
Internet/Phone: Internet IPv4 (because the device is being configured to connect
over the internet).
Site Phone/IP address: The static IP and port number used to connect to the device.
[Use the port number configured for Cloud Link 'Server mode IP port number' =
3111, refer Modem Item Numbers under Appendex section.]
Other fields displayed on the screen can be left blank.
Click Save to continue. The site is added to the list of sites on the Site Management screen.
Honeywell
| 39