ABB FSPS-21 User Manual page 53

No. Name/Value
28 FBA A/B par table ver
29 FBA A/B drive type
code
30 FBA A/B mapping file
ver
31 D2FBA A/B comm
status
0 = Idle
1 = Exec.init
2 = Time out
3 = Conf.err
4 = Off-line
5 = On-line
6 = Reset
32 FBA A/B comm SW
ver
Description
Read-only. Displays the parameter table revision of
the fieldbus adapter module mapping file stored in the
memory of the drive. In format xyz, where
x = major revision number
y = minor revision number
z = correction number
OR
in format axyz, where
a = major revision number
xy = minor revision numbers
z = correction number or letter.
Parameter table revision
Read-only. Displays the drive type code of the fieldbus
adapter module mapping file stored in the memory of
the drive.
Drive type code of the fieldbus adapter module map-
ping file
Read-only. Displays the fieldbus adapter module
mapping file revision stored in the memory of the drive
in decimal format.
Mapping file revision
Read-only. Displays the status of the fieldbus adapter
module communication.
Note: The value names may vary by drive.
Note: Only active drive-controlled channel will change
comm status online. PROFIsafe alone will not change
the comm status.
Adapter is not configured
Adapter is initializing.
A timeout has occurred in the communication between
the adapter and the drive.
There is an internal error in the communication
between the adapter and the drive. Contact your local
ABB representative.
Adapter is off-line
Adapter is on-line
Adapter is performing a hardware reset.
Read-only. Displays patch and build numbers of the
adapter module's firmware version in xxyy format,
where:
xx = patch number
yy = build number.
Example: If the firmware version (<ma-
jor>.<minor>.<patch>.<build>) is 3.10.200.13, the value
C80D is displayed. If the version is 3.10.0.0, the value
0 is displayed.
See also parameter 33.
PROFINET IO – Start-up 53
Default
N/A
N/A
N/A
0 = Idle
or
4 = Offline
N/A