Network Setup - Vertiv VP8641 Manual

VERTIV INTELLIGENT RACK PDU
4.2.2. NETW ORK SET UP
The Vertiv Upgradeable IMD has a default IP address for initial setup and access. To remove configured IP
addresses and restore the unit to it's default IP address and reset all user-account information, if the user-
assigned address or passwords are lost or forgotten, press and hold the network-reset button located
below the Ethernet port number 2 for 5 seconds. Holding the center button of the LED display for 10 sec-
onds will also reset the network and user account information.
The Network page (located under the System Tab) allows you to assign the network properties manually,
or use DHCP to connect to your network. Access to the unit requires the IP address to be known. Use of
a static IP or a reserved DHCP is recommended. The default address is shown on the front of the unit:
Table 2-1
IP Address:
Subnet Mask:
Gateway:
To access the unit for the first time, you will need to temporarily change your computer's network settings
to match the 192.168.123. xxx subnet. To set up the unit, connect it to your computer's Ethernet port,
then follow the appropriate instructions for your computer's operating system.
Windows
· Windows 2000 / XP / Server 2003:
Click the Start button, choose Settings, then Network Connections.
· Windows 7 / Server 2008:
Click the Start button, then choose Control Panel >> Adjust Your Computer's Settings >> View Net-
work Status and Tasks >> Change Adapter Settings.
(Alternatively, on some Windows 7 machines, this may be Start, then Settings >> Control Panel >> Net-
work and Sharing Center >> Change Adapter Settings.)
· Windows 8 / Server 2012:
Move the mouse cursor to the bottom or top right corner of the screen, click the Settings icon, then select
Control Panel. Change the view type from Category to Large or Small Icons if necessary, then select
Network and Sharing Center, then Change Adapter Settings.
Default IP Address
192.168.123.123
255.255.255.0
192.168.123.1
Page 30