Technical Support; Resetting Pdu; Service And Maintenance; Using Microsoft Exchange As An Smtp Server - Vertiv VP8641 Manual

VERTIV INTELLIGENT RACK PDU
5.7. T ECHNIC AL SU PPO RT
5.7.1. RES ET T ING PDU
Should the PDU lose communication, the following reset/reboot buttons are available to
help with troubleshooting:
1. Network-Reset Button (
a small pin or paper clip to contact this button. Holding the Network-Reset button for 5
seconds during normal operation will restore the default IP address and reset the
user accounts.
2. Hard-Reboot Button (
device. This acts as a power-cycle for the device, and does not change or remove
any user information.
5.7.2. SER VICE A ND MAIN T ENA NC E
•
No service or maintenance is required.
•
There are no serviceable parts inside the PDU.
5.7.3. USING MIC ROSOFT E X CHA NGE AS A N S MT P S ER VER
If your facility uses a Microsoft Exchange email server, it can be used by the Vertiv Upgradeable PDU to
send Alarm and Warning notification emails if desired. However, the Exchange server may need to be
configured to allow SMTP connections from the unit first, as later version of Exchange often have SMTP
services or basic authentication disabled by default. If you encounter difficulties in getting your IMD PDU
to send emails through your Exchange server, the following notes may be helpful in resolving the problem.
) : Located under the Ethernet port, users will need to use
): Pressing the Hard-Reboot button reboots the monitoring
NOTE
This will NOT affect power to the connected devices.
WARNING
Do not attempt to open the PDU or the warranty will be void.
Page 96