Vertiv VP8641 Manual page 36

VERTIV INTELLIGENT RACK PDU
5. Display Buttons: There are three buttons near the IMD display; a back button, a forward but-
ton, and a center button. The functions of these buttons are as follows:
Back Button
Forward Button
Center Button
and
Decrement to the previous channel.
Holding this button for 3 seconds initiates a
The display will show a "bcup" message while the backup is being
generated and will then go back to normal operation.
Increment to the next channel.
Holding this button for 3 seconds initiates a
The display will show a "rest" message followed by a "conf" mes-
sage and then a 3 second countdown. Once the countdown ex-
pires, a "8888" message is displayed and the backup will be ap-
plied. If the button is released at any time during this sequence, the
restore is aborted. The display will then go back to normal opera-
tion.
Toggle between scrolling and static display modes.
Holding this button for 3 seconds initiates a parameter reset se-
quence. This sequence consists of a "rset" message, followed by a
"dflt" message and then a 3 second countdown. Once the count-
down expires, a "8888" message is displayed and the network, http,
user accounts, and LDAP information is reset to default values. If
the button is released at any time during this sequence, the reset is
aborted.
Flip the display 180 degrees. Both buttons must be pressed at the
same time.
Page 36
configuration backup.
configuration restore.