Chapter 4 - Final Checkout - Vertiv VP8641 Manual

VERTIV INTELLIGENT RACK PDU
6. CH AP TE R 4 - FIN AL CH E CKOU T
6.1. PRODU CT -SPECIFI C SAF ET Y NOT ICES
The specific procedural safety precautions relating to this product are stated below.
6.1.1. GENER AL SA FET Y
Safety is a serious matter and all precautions should to taken to guarantee a safe work and
operational environment. General safety precautions must be observed during all aspects of
operation, service, and repair of equipment described in this document. Failure to comply with
the safety warnings, procedures and guidelines as presented in this document is in violation of
the safety standards of design, manufacture, and intended use of this equipment.
You are responsible for following the safety guidelines and warnings presented in this docu-
ment for this equipment. Individuals using or maintaining Vertiv product(s) are expected to fol-
low all the noted warnings and safety precautions necessary for safe operation of the equip-
ment in your environment. Vertiv assumes no liability for failure to comply with these require-
ments.
6.1.2. LIVE CIR CUIT S SAF ET Y
Operating personnel must:
•
Not remove equipment covers. Only Vertiv Authorized Service Personnel or other qualified
maintenance personnel may remove equipment covers for internal sub-assembly, or compo-
nent replacement, or any internal adjustment.
•
Not replace any equipment component with power applied to the line cord. Under certain con-
ditions, dangerous voltages may exist even with the input power cable disconnected. Any ex-
ceptions for 'Hot-Swap' modules will be specifically noted in this product document.
•
Always disconnect input power and discharge circuits before touching any sub-assembly of
circuit component.
DANGER
HAZARDOUS VOLTAGE, CURRENT, AND ENERGY LEVELS ARE PRE-
SENT IN THIS PRODUCT. POWER SWITCHED CIRCUITS CAN HAVE
HAZARDOUS VOLTAGES PRESENT EVEN WHEN THE SWITCH IS IN
THE OFF POSITION. DO NOT OPERATE THE PRODUCT WITH ANY
COVER PLATE REMOVED. ALWAYS MAKE SURE THAT PRODUCT IS
FULLY ENCLOSED PRIOR TO USE.
Page 98