Vertiv VP8641 Manual page 65

VERTIV INTELLIGENT RACK PDU
•
Target is the e-mail address or SNMP manager to which notifications should be sent when the
Event is tripped. Other options, such as "buzzer", may be available depending on your Vertiv
PDU.
•
Delay determines how long this Event must remain tripped before this Action's first notification is
sent. (Note that this is different from the Trip Delay, above; Trip Delay determines how long the
threshold value has to be exceeded before the Event itself is tripped.) Delay can be up to 14400
seconds (4 hours). A Delay of 0 will send the notification immediately.
•
Repeat determines whether multiple notifications will be sent for this Event Action. Repeat notifi-
cations are sent at the specified intervals until the Event is acknowledged, or until the Event is
cleared and reset. The Repeat interval can be up to 14400 seconds (4 hours). A Repeat of 0
disables this feature, and only one notification will be sent.
Then, click Save to save this notification Action.
If required, multiple Actions can be set for an Alarm or Warning; to add multiple Actions click the
Add icon again and set each one as desired. Each alert can have up to 32 Actions associated with
it.
To change an existing notification Action, click the Modify icon next to the Action you wish to
change, then modify its settings as above.
Once an Action has been added, each Action has its own checkbox in the "enabled" column at the
far left. The default is unchecked (disabled) when you first add each Action; set the checkbox to
enable it. (This allows you to selectively turn different Actions on and off for testing.)
To remove a notification Action entirely, click the Delete icon to remove the Action from the list, then
click Delete to confirm:
3.
When finished, click Save to save this Alarm or Warning event.
To change an existing Alarm or Warning Event:
Figure 3-24 Modify Action
Figure 3-25 Delete Action
Page 66