Vertiv VP8641 Manual page 74

VERTIV INTELLIGENT RACK PDU
•
Hostname: The Hostname may be used as a method for device identification on the network.
•
Interfaces: This section is used to configure the IP address of the PDU, enable/disable DHCP and to
view Link State and Uptime. The device will support up to 8 user configured IP address entries.
•
Ports: Used to view and/or modify Ethernet port settings and RSTP status of each port on PDU.
•
Routes: Displays configured routes and is where you will set your Gateway address for the PDU. De-
fault routes are distinguished by a "destination" of "0.0.0.0" or "::", with a Prefix of "0" and Interface of
"all". Only one default route can exist for IPv4 and one for IPv6.
•
DNS: Allows the unit to resolve host names for email, NTP, and SNMP servers.
•
RSTP: This section is used to Enable/Disable RSTP and/or modify RSTP settings
To edit the Interfaces parameters:
1.
Click the Modify icon
2.
Modify desired fields which include:
a. Label - Change the desired name of the selected interface.
b. Enable - Enable/Disable the selected interface. Please note that if only one
interface is available/configured, disabling the interface will restrict
access to the device requiring a network reset.
c. DHCP - Enable/Disable DHCP on the selected interface. DHCP is enabled by
default and will be disabled if a static IP address is configured.
3.
Click the Save button
Figure 3-32 Editing Interfaces Parameters
Page 75