Vertiv VP8641 Manual page 34

VERTIV INTELLIGENT RACK PDU Page 34
Once the NIC settings are configured properly, you should be able to access the unit by typing
http://192.168.123.123 into the address bar of your web browser. If you are setting up the unit for the first
time, or if the unit has been reset back to factory defaults via the network-reset button, the unit will require
you to create an Admin account and password before you can proceed.
Once you have created the Admin account and logged into it, the unit's default Sensors page should
come up by default. Navigate to the System tab, then the Network page to configure the device's net-
work properties. The unit's IP Address, Subnet Mask, Gateway, and DNS settings can either be assigned
manually, or acquired via DHCP.
The new settings will take effect when the Save button is clicked, so the browser will no longer be able to
reload the web page from the 192.168.123.123 address and will probably display a "page not found" or
"host unavailable" message. This behavior is normal. Once you have finished configuring the unit's IP ad-
dress, simply repeat the steps above, and change the computer's Ethernet NIC card settings back to the
ones you wrote down prior to changing them, to restore its normal network and internet settings.