Vertiv VP8641 Manual page 32

Intelligent rack pdu
Table of Contents

Advertisement

VERTIV INTELLIGENT RACK PDU
Page 32
Find the entry titled "Internet Protocol Version 4 (TCP/IPv4)" in the list, then click the Properties button
to open the Internet Protocol Properties window. If you see more than one TCP/IP entry, as in the ex-
ample above, the computer may be configured for IPv6 support as well as IPv4; make sure to select the
entry for the IPv4 protocol. Write down the current NIC card settings so you can restore them to normal
after you have completed the setup procedure.
Figure 2-16 Internet Protocol Version 4
Choose the Use the following IP address option, then set IP address to 192.168.123.1 and Subnet
Mask to 255.255.255.0. For this initial setup, Default Gateway and the DNS Server entries can be left
blank. Select OK, then OK again to close both the Internet Protocol Properties and Local Properties
windows.
Once the NIC settings are configured properly, you should be able to access the unit by typing
http://192.168.123.123 into the address bar of your web browser. If you are setting up the unit for the first
time, or if the unit has been reset back to factory defaults via the network-reset button, the unit will require
you to create an Admin account and password before you can proceed.
Once you have created an Admin account and have logged into it, the unit's default Sensors page should
come up by default. Navigate to the System tab, then the Network page to configure the device's net-
work properties. The unit's IP Address, Subnet Mask, Gateway, and DNS settings can either be assigned
manually, or acquired via DHCP.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents