Syslog - Vertiv VP8641 Manual

VERTIV INTELLIGENT RACK PDU
Figure 3-56 SNMP Traps/Types IP Configuration Page
To configure a trap destination:
1. Locate the Traps section of the SNMP page, and click on the Add icon.
2. Enter the IP Address which the trap should be sent to in the Host field, change the Port number if
required, select the trap Version to be used (v1, v2c, or v3), and click Save.
A test trap may be sent by clicking on the Test icon next to the Host IP address. Trap settings can also be
updated/changed by clicking the Modify icon next to the Host IP address.
5.5.11.

SYSLOG

Syslog data can be captured remotely but must first be setup and enabled via the Syslog page.
NOTE
This function is primarily only useful for diagnostic purposes, and should
normally be left Disabled unless advised to enable it by Vertiv technical sup-
port for troubleshooting a specific issue.
Page 90