Mechanical installation
Installation of Zone Division
2.4 Installation of Zone Division
2.4.1 Installing the Zone Division
Följ anvisningarna nedan för att montera zonindelningen:
1. Position the aluminium section (A) and
2. Screw the switches (C) on the
2-24
Action
tighten the bracket (B).
Make sure that the aluminium section
(A) is completely straight.
carriage.
Adjust so that the switches are approx.
10 mm from the cam section in
disabled mode.
Do not adjust too closely!
The switch must NOT touch bottom
when it is actuated. There must be a
remaining gap of 1 mm.
Info/Illustration
3HEA 800 970-001 Rev. D, Mars 2006