Festo CPX-FVDA-P2 Original Instructions Manual page 9

General safety instructions
– Operation of the CPX-FVDA-P2 is permissible only in combination with the following PROFIsafe-
compatible CPX bus nodes è Bus node rating plate:
Bus node
CPX-FB13
1)
CPX-FB33
2)
2)
CPX-M-FB34
2)
CPX-M-FB35
1) è Description CPX-FB13...
2) è Description CPX-PNIO...
Tab. 1 Permissible PROFIsafe-compatible CPX bus nodes
– Operation of the CPX-FVDA-P2 within valve terminals is only permissible with the following valve
types:
Valve terminal
MPA-S-FB-VI
MPA-F-FB-VI
VTSA-FB-VI
VTSA-F-FB-VI
VTSA-F-CB-VI
1) Malfunctions may occur if the resultant current is exceeded.
Tab. 2 Permissible valve types
– Operation of shut-off groups within valve terminals is only allowed in conjunction with permissible
pneumatics è Description of the respective valveterminal.
– Operation of shut-off groups in CPX terminals in the Remote I/O operating mode is only allowed
with the following approved output modules:
Output module
CPX-4DA
1)
1)
CPX-8DA
CPX-8DA-H 1)
CPX-8DE-8DA 1)
1) Malfunctions may occur if the resultant current is exceeded.
Tab. 3 Permissible output modules
Festo — CPX-FVDA-P2 — 2018-10b
From revision
30
21
21
21
Type Valve types
32 MPA1, MPA2 on VMPA...-FB-EMG-...
33 MPAF1, MPAF2 on VMPA...-FB-EMG-...
44 All up to width of 52 mm
45 All up to width of 52 mm
1)
46 All
Network protocol
PROFIBUS
PROFINET IO
PROFINET IO
PROFINET IO
1)
1)
1)
1)
9