Festo CPX-FVDA-P2 Original Instructions Manual page 75

Commissioning
The output module name [FVDO-P2 Output Module Safety] is displayed in the main menu of the oper-
ator unit. The short text [FVDO-P2] is displayed in the header of the operator unit. An example is
shown in the diagram below:
System overview
CPX-Terminal
0: FB34-RIO Profinet Remote I/O
1: 2AI Analogue Input Module
1
2: 2AI Analogue Input Module
3: FVDO-P2 Output Module Safety
Diag
1
Module identifier in the main menu (here as
module 3)
Fig. 26 Module identifier of the output module CPX-FVDA-P2 on the operator unit
The following image shows an example of the special displays for the output module CPX-FVDA-P2.
Note that the menus [Forcing], [Fail safe] and [Idle mode] are not supported for the output module
CPX-FVDA-P2.
Festo — CPX-FVDA-P2 — 2018-10b
<-
<--> OK
Monitoring (M)
Diagnostics (D)
Parameters (P)
Module data (MD)
Back
3: FVDO-P2
OK
2
Module identifier in the header of the sys-
tem submenu for a module
2
->
75