Festo CPX-FVDA-P2 Original Instructions Manual page 30

System overview CPX-FVDA-P2
Product versions
Valve terminal
MPA-S-FB-VI
MPA-F-FB-VI
VTSA-FB-VI
VTSA-F-FB-VI
VTSA-F-CB-VI
1) Malfunctions may occur if the resultant current is exceeded.
Tab. 17 Supported product versions of the valve terminals named above
Other product versions are not supported by the output module CPX-FVDA-P2 at output channel CH0.
Operation of switch-off groups within valve terminals is only allowed in conjunction with permissible
pneumatics è description of the respective valve terminal.
Only the following components are permitted when assembling the CPX-FVDA-P2 in a CPX terminal or
the pneumatic interface of a valve terminal VTSA-F-CB:
Version
1 CPX-FVDA-P2 in combination
with particular manifold and
interlinking blocks of the
CPX terminal
2 CPX-FVDA-P2
pneumatic interface of the
3
valve terminal VTSA-F-CB
1) Revision R04 (or a higher revision) of the output module is required è Rating plate of the electronics module CPX‑FVDA‑P2
Tab. 18 Permissible components
NOTICE!
When using the CPX-FVDA-P2 in a pneumatic interface, the module's self-monitoring function can trig-
ger false diagnoses in certain cases.
• In the "Wire break monitoring" parameter of the pneumatic interface, deactivate the wire break
detection function for the output channels CH0, CH1 and CH2.
NOTICE!
When using individual pneumatic modules of types VMPA-... or VTSA-..., the "Wire break" diagnostic
message may be triggered as the detection limit is undershot.
• In this case, deactivate the "Wire break" diagnostic message for the respective output channel.
30
Type
32
33
44
45
46
Component
Interlinking block
Manifold block
as part of the Pneumatic interface
1)
Valve types
MPA1, MPA2 on VMPA...-FB-EMG-...
MPAF1, MPAF2 on VMPA...-FB-EMG-...
All up to width of 52 mm
All up to width of 52 mm
All 1)
Type
CPX-M-GE-EV-FVO
CPX-M-AB-4-M12X2-5POL
CPX-AB-8-KL-4POL
VABA-S6-1-X...-F1-CB
VABA-S6-1-X...-F2-CB
Festo — CPX-FVDA-P2 — 2018-10b
1)
1)
1)
1)