Terminal Mode Operation; D Setting The Terminal Mode - Icom IC-9700 Advanced Manual

11. ABOUT THE DV GATEWAY FUNCTION

Terminal mode operation

D Setting the Terminal mode

1. Open the DV GATEWAY screen.
» (2) > DV GW
MENU
2. Touch "<<Terminal Mode>>."
Internal Gateway icon
When using the External Gateway function
After the transceiver is in the Terminal mode, click
(touch) <Start> in the RS-MS3W or RS-MS3A.
L If an error message is displayed, see page 11-24 to read
the tips to solve the problem.
NOTE: In the Terminal mode
• The Time Out Timer function is not activated.
• The Following items are automatically set.
Mode: DV mode*
DR function: ON (MAIN band)*
FROM: MY Call Sign
Dualwatch function: OFF*
AFC function: OFF
RIT function: OFF
P.AMP function: OFF
EXT P.AMP function: OFF
ATT function: OFF
IP+ function: OFF
TX PWR LIMIT function: OFF
* These settings do not return to the previous
settings, even if you cancel the Terminal mode.
• The Terminal mode is not automatically canceled,
even if you turn OFF the transceiver, then turn it
ON again.
"Ext" is displayed when using the
External Gateway function.
TIP: Canceling the Terminal mode
Touch "<<Normal Mode>>" in the DV GATEWAY
screen.
» (2) > DV GW > <<Normal Mode>>
MENU
L When using the External Gateway function, click
(touch) <Stop>
before the transceiver returns to the normal mode.
About the Internal Gateway icon
When using the Internal Gateway function, displays
the communication status.
Icon Status
In the standby mode
While transmitting
While receiving
Transmission error (The repeater is busy.)
Transmission error
Network error
Receiving while transmitting
Receive error
L If an error icon is displayed, see page 11-19 to read the
tips to solve the problem.
11-12
in the RS-MS3W or RS-MS3A