Advanced Operations; Operating Cw (Advanced); D About The Cw Reverse Mode; D Using The Memory Keyer Function (Keyer) - Icom IC-9700 Advanced Manual

1. ADVANCED OPERATIONS

Operating CW (ADVANCED)

D About the CW Reverse mode

The CW-R (CW Reverse) mode reverses the receive
Beat Frequency Oscillator (BFO) to receive CW
signals.
Use this when interfering signals are near the desired
signal and you want to use the CW-R to reduce
interference.
CW mode (USB side)
BFO
Desired Interference
signal
TIP: Reversing the carrier point
The carrier point of the CW mode is USB by default.
You can change it to LSB on the FUNCTION screen.
» SET > Function > CW Normal Side
MENU
L When this setting is set to "LSB," the CW and CW-R
modes are reversed.
CW-R mode (LSB side)
BFO
Desired Interference
signal

D Using the Memory Keyer function (KEYER)

You can send preset characters using the Memory
Keyer function.
Sending
1. Display the KEYER screen.
» KEYER
MENU
L The [KEYER] key is displayed only in the CW mode.
2. Push
TRANSMIT
• The TX/RX indicator lights red.
L If you want to automatically switch between transmit
and receive, turn ON the Break-in function (See
Basic manual section 4).
3. Touch a Memory Keyer key between [M1] and [M8].
(Example: [M1])
Sending contents
• The touched Memory Keyer is sent.
4. To repeatedly send the Memory contents, touch
the Memory Keyer key for 1 second.
Repeat icon
L The Memory contents will be repeatedly sent,
according to the setting in "Keyer Repeat Time."
L To stop sending, touch the Memory Keyer key again.
Key
Touch
M1 ~ M8 Touch for
1 second
Reduces the contest number counter by 1 (001).
–1 L You can change or reset the number in "Present
001
Number" in the KEYER 001 menu. (
manual section 4
Touch to display the EDIT/SET screen.
EDIT/SET
1-1
.
Action
Sends the Memory keyer contents
is displayed and repeatedly
sends the Memory keyer contents.
L You can change the repeat interval
setting in "Keyer Repeat Time"
in the CW-KEY SET menu. (
Basic manual section 4
See Basic
)
See
)